348500 (TYPE 6) - Bulkhead, Series 2a, 4-cylinder, Rover 10 or 11 Land-Rover Series 2a £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2a, 4-cylinder, Rover 10 or 11 Suitable only for Military specification Rover 10 and 11, Series 2a models, circa 1967. Remanufactured to our usual high specification. For identification purposes, this version of the Series 2a bulkhead features the following: Holes for 'quadrant' type vent controls. Later dipswitch with wiring to the side. Spot welded door check tubes. Angled Tie Rod Brackets Voltage regulator and fuse box mounted direct to bulkhead. Access hole for clutch slave cylinder bleed nipple. No drain lip along top rear edge of bulkhead. Holes for Round Heater and Flat Heater option. Holes for Round Heater and Flat Heater demister tubes. No auxiliary panel for hand throttle, choke, diesel engine stop etc. Single wiper motor fitted to rear face of glovebox. Pressing in left hand side of Glovebox Back Panel to allow clearance for wiper motor. Wings (fenders) secured with Spire nuts and screws. Door hinges secured with 5/16" UNF screws into captive nut plates. Holes for Auxiliary Tank Switchover Tap in RH Footwell. Holes for Small Arms Clips above Instrument Panel. Extra large holes for 24v cabling and ducting. Inner Ventilator Panel pre-drilled for Series 2a type Fly Screens. Glove box Back Panel pre-drilled to accept Contract Plate. Picture shows CAD drawing in progress.