348500 (TYPE 8) - Bulkhead, Series 2a, 4-cylinder, Rover 10 or 11 Land-Rover Series 2a £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2a, 4-cylinder, Rover 10 or 11 Suitable only for Military specification Rover 10 and 11, Series 2a models, circa 1969. Remanufactured to our usual high specification. For identification purposes, this version of the Series 2a bulkhead features the following: Holes for 'quadrant' type vent controls. Later dipswitch with wiring to the side. Spot welded door check tubes. Straight Tie Rod Brackets Voltage regulator and fuse box mounted direct to bulkhead. Access hole for clutch slave cylinder bleed nipple. Holes for Round Heater and Flat Heater option. Holes for Round Heater and Flat Heater demister tubes. No auxiliary panel for hand throttle, choke, diesel engine stop etc. Single wiper motor fitted to rear face of glovebox. Wings (fenders) secured with Spire nuts and screws. Door hinges secured with Spire nuts. Holes for Auxiliary Tank Switchover Tap in RH Footwell. Holes for Small Arms Clips above Instrument Panel. Extra large holes for 24v cabling and ducting. Inner Ventilator Panel pre-drilled for Series 2a type Fly Screens. Glove box Back Panel pre-drilled to accept Contract Plate. Picture shows CAD drawing in progress.