MRC 6080 (TYPE 4) - Bulkhead, Series 3, 4-cylinder from November 1975
Land-Rover Series 3
Manufactured to order.
Bulkhead, Series 3, 4-cylinder from November 1975
Late Series 3 universal type that fits 4-cylinder models only.
Long Rain Channel.
Series 3 style Inner Ventilator Panel.
Series 3 type Inner Stiffeners, Inner Vent Panel to Door Pillars.
Gearbox Tunnel Diaphragm Plate fitted with Lokut nuts to Middle Panel and Footwell Side Panels. Allows rationalistion of bulkhead to 4-cylinder or V8 models.
Mix of UNF and Metric threads.
'Large' wiring ducts.
Whilst this bulkhead part number was used as a service replacement for 109 V8 models, there are minor differences that are not original and would have been omitted or drilled on the original production line, so we have created a new part number, MRC 6080 (TYPE 5) for the 109 V8 bulkhead.
If fitting to 109 V8 model, the following modifications would be required:
Delete 2 off Rivnuts used for the 2¼ Diesel Ballast Resistor.
Delete 2 off Rivnuts used for 2¼ Diesel Fuel Filter.
Drill 2 holes to fit Throttle Cable Bracket to Footwell Side Panel.
Drill 1 hole in Bottom Middle Cap Panel for Heater Tap Control Cable.
Drill 2 holes in Middle Panel for V8 Fuel Filter Housing.
4 holes for Permanent Four Wheel Drive Warning Plate should be drilled through trim panel into Middle Panel.