345879 (TYPE 1) - Bulkhead, Series 2, 1958 to 1959 Land-Rover Series 2 £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2, 1958 to 1959 Suitable only for Series 2 models from March 1958 to December 1959.Remanufactured to our usual high specification.For identification purposes, this version of the Series 2 bulkhead features the following: Holes in parcel shelf for 'screw' type vent controls. Holes in footwells for early Lucas FS22-1 dipswitch with rear wiring. Holes for 'bolt on' door check tubes. Angled tie rod brackets. Right hand Bonnet Hinge with locating lug. Holes for voltage regulator mounting plate. No access hole for clutch slave cylinder bleed nipple. Drain lip along top rear edge of bulkhead. Holes for Round Heater option. Lower auxiliary panel for hand throttle, choke, diesel engine stop etc. Seperate wiper motors for driver and passenger are fitted to windscreen. Captive nuts and cages for wing (fender) fastening. Captive nut plates for door hinge fastening. Picture shows engineering prototype with RAL 9006 (White Aluminium) powder coated finish.