345879 (TYPE 2) - Bulkhead, Series 2, January 1960 to May 1960 Land-Rover Series 2 £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2, January 1960 to May 1960 Suitable only for Series 2 models from January 1960 to c. May 1960. Remanufactured to our usual high specification. For identification purposes, this version of the Series 2 bulkhead features the following: Holes for 'screw' type vent controls. Later Lucas 21SA dipswitch with wiring to the side. Holes for 'bolt on' door check tubes. Angled tie rod brackets. Right hand Bonnet Hinge with locating lug. Holes for voltage regulator mounting plate. Access hole for clutch slave cylinder bleed nipple. Drain lip along top rear edge of bulkhead. Holes for Round Heater option. Lower auxiliary panel for hand throttle, choke, diesel engine stop etc. Separate wiper motors for driver and passenger are fitted to windscreen. Wings (fenders) secured with Spire nuts and screws. Captive nut plates for door hinge fastening. Picture shows CAD drawing.