345879 (TYPE 3) - Bulkhead, Series 2, May 1960 to January 1962

Bulkhead, Series 2, May 1960 to January 1962

Suitable only for Series 2 models from c.May 1960 to January 1962.

Remanufactured to our usual high specification.

For identification purposes, this version of the Series 2 bulkhead features the following:

• Holes for 'quadrant' type vent controls.
• Later dipswitch with wiring to the side.
  
• Holes for 'bolt on' door check tubes.
• Angled tie rod brackets.
• Right hand Bonnet Hinge with locating lug.
  
• Holes for voltage regulator mounting plate.
• Access hole for clutch slave cylinder bleed nipple.
• Drain lip along top rear edge of bulkhead.
  
• Holes for Round Heater option.
• Lower auxiliary panel for hand throttle, choke, diesel engine stop etc.
• Separate wiper motors for driver and passenger are fitted to windscreen.
• Wings (fenders) secured with Spire nuts and screws.
  
• Captive nut plates for door hinge fastening.
  

Photograph shows serial number 022, phosphate coated with Pastel Green wet paint finish.