345879 (TYPE 4) - Bulkhead, Series 2a, 4-cylinder, February 1962 to March 1967

Bulkhead, Series 2a, 4-cylinder, February 1962 to March 1967

Suitable only for Series 2a models from February 1962 to c.March 1967.

Remanufactured to our usual high specification.

For identification purposes, this version of the Series 2a bulkhead features the following:

• Holes for 'quadrant' type vent controls.
• Later dipswitch with wiring to the side.
  
• Spot welded door check tubes.
• Angled tie rod brackets.
• Right hand Bonnet Hinge without locating lug.
  
• Voltage regulator and fuse box mounted direct to bulkhead.
• Access hole for clutch slave cylinder bleed nipple.
• Drain lip along top rear edge of bulkhead.
  
• Holes for Round Heater option.
• Lower auxiliary panel for hand throttle, choke, diesel engine stop etc.
• Separate wiper motors for driver and passenger are fitted to windscreen.
• Wings (fenders) secured with Spire nuts and screws.
  
• Captive nut plates for door hinge fastening.
  

 Picture shows bulkhead Serial Number 006 in Red Oxide Primer finish.