345879 (TYPE 5) - Bulkhead, Series 2a, 4-cylinder, March 1967 to October 1968 Land-Rover Series 2a £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2a, 4-cylinder, March 1967 to October 1968 Suitable only for Series 2a models from c.March 1967 to c.October 1968. Remanufactured to our usual high specification. For identification purposes, this version of the Series 2a bulkhead features the following: Holes for 'quadrant' type vent controls. Later dipswitch with wiring to the side. Spot welded door check tubes. Angled tie rod brackets. Right hand Bonnet Hinge without locating lug. Voltage regulator and fuse box mounted direct to bulkhead. Access hole for clutch slave cylinder bleed nipple. Holes for Round Heater option and Flat Heater option. Small round hole for Diesel Engine Speed Hand Control linkage. Single wiper motor fitted to left hand side of glovebox. Holes in ventilator panels for wiper spindles. Holes only in inner ventilator panel for washer jets. Pressing in left hand side of Glovebox Back Panel to allow clearance for early wiper motor with square body. Wings (fenders) secured with Spire nuts and screws. Captive nut plates for door hinge fastening. Picture shows CAD drawing.