345879 (TYPE 6) - Bulkhead, Series 2a, 4-cylinder, October 1968 to December 1968

Bulkhead, Series 2a, 4-cylinder, October 1968 to December 1968

Suitable only for Series 2a models from c.October 1968 to December 1968.

Remanufactured to our usual high specification.

For identification purposes, this version of the Series 2a bulkhead features the following:

• Holes for 'quadrant' type vent controls.
• Later dipswitch with wiring to the side.
  
• Spot welded door check tubes.
• Angled tie rod brackets.
• Right Hand Bonnet Hinge without locating lug.
• Voltage regulator and fuse box mounted direct to bulkhead.
  
• Access hole for clutch slave cylinder bleed nipple.
• Holes for Flat Heater option.
• Holes for Round Heater demister tubes.
  
• Small 'letterbox' hole for Diesel Engine Speed Hand Control.
• Single wiper motor fitted to left hand side of glovebox.
• Holes in ventilator panels for wiper spindles.
• Holes only in inner ventilator panel for washer jets.
• Pressing in left hand side of Glovebox Back Panel to allow clearance for early wiper motor with square body.
  
• Wings (fenders) secured with Spire nuts and screws.
  
• Captive nut plates for door hinge fastening.
• Grab handle with holes for Brake Failure Warning Lamp.
  

Picture shows CAD drawing.