345879 (TYPE 7) - Bulkhead, Series 2a, 4-cylinder, January 1969 to September 1969 Land-Rover Series 2a £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2a, 4-cylinder, January 1969 to September 1969 Suitable only for Series 2a models from January 1969 to September 1969. Remanufactured to our usual high specification. For identification purposes, this version of the Series 2a bulkhead features the following: Holes for 'quadrant' type vent controls. Later dipswitch with wiring to the side. Spot welded door check tubes. Angled tie rod brackets. Right hand Bonnet Hinge without locating lug. Voltage regulator and fuse box mounted direct to bulkhead. Access hole for clutch slave cylinder bleed nipple. Holes for Flat Heater option. Holes for Round Heater demister tubes still present. Single wiper motor fitted to rear face of glovebox. Holes in ventilator panels for wiper spindles. Holes only in inner ventilator panel for washer jets. No pressing in rear of Glovebox Back Panel to allow clearance for later wiper motor with round body. Wings (fenders) secured with Spire nuts and screws. Captive nut plates for door hinge fastening. Grab Handle with holes for Brake Failure Warning Lamp. Holes in Footwell Plates for mechanical Stop Lamp Switch. Engine Speed Hand Control moved to left hand glovebox (Vertical type Hand Control) Picture shows CAD drawing.