345879 (TYPE 8) - Bulkhead, Series 2a, 4-cylinder, October 1969 onwards Land-Rover Series 2a £2200.00 Quantity: at £2200.00 each Out of Stock Manufactured to order Bulkhead, Series 2a, 4-cylinder, October 1969 onwards Suitable only for Series 2a models from October 1969 onwards. Remanufactured to our usual high specification. For identification purposes, this version of the Series 2a bulkhead features the following: Holes for 'quadrant' type vent controls. Later dipswitch with wiring to the side. Spot welded door check tubes. Straight tie rod brackets. Right hand Bonnet Hinge without locating lug. Voltage regulator and fuse box mounted direct to bulkhead. Access hole for clutch slave cylinder bleed nipple. Holes for Flat Heater option. Holes for Round Heater demister tubes still present. Single wiper motor fitted to rear face of glovebox. No pressing in rear of Glovebox Back Panel to allow clearance for later wiper motor with round body. Wings (fenders) secured with Spire nuts and screws. Door hinges secured with Spire nuts. Grab handle with holes for Brake Failure Warning Lamp. Holes in Footwell Plates for mechanical Stop Lamp Switch. Engine Speed Hand Control moved to left hand glovebox (Vertical type Hand Control) Picture shows CAD drawing.